VZ1 0 Posted June 4, 2006 Try to wire up PTZ cam to a DVR. DVR have a dsub-15p rs485 male connecter. meun show pin 1 rs485 +,pin 2 rs485 -, pin 8 ground. the ptz cam is panasonic .it has a ps data wire (5 wires inside) ,Brown--ground, Red-- data transmission T(B),Orange--data transmission T(A),Yellow--datd reception R(B), Green--data reception R(A). Which 2 wires I need to wire up the DVR pin 1 & pin 2? Thank. Share this post Link to post Share on other sites
VST_Man 1 Posted June 4, 2006 pin 1 rs485 + to Green--data reception R(A) pin 2 rs485 to Yellow--datd reception also set your termination via the dip switches.................if this is a single PTZ or at the long end of the wire(s), set termination "on" Share this post Link to post Share on other sites
VZ1 0 Posted June 4, 2006 This is a single PTZ. the 8-bit dip sw # 1 you mean. Share this post Link to post Share on other sites
VZ1 0 Posted June 4, 2006 still can't get it working.I must did something wrong here. Please help. Share this post Link to post Share on other sites
Securitymaster 0 Posted June 4, 2006 Are you using the proper protocol? What DVR is it? and what model PTZ is it? Share this post Link to post Share on other sites
VZ1 0 Posted June 5, 2006 speco dvr-t4ip ,I set it Pelco D,4800 baud rate. Thank Share this post Link to post Share on other sites
VZ1 0 Posted June 5, 2006 Panasonic Wv-c864 . Thank Share this post Link to post Share on other sites
VZ1 0 Posted June 7, 2006 Panasonic wv-cw 864 is this camera ptz protocol pelco p .Can any body confirm. Share this post Link to post Share on other sites
Securitymaster 0 Posted June 7, 2006 I looked at the manual for the camera, and the website, but I cannot find anything about protocols. rory, help Share this post Link to post Share on other sites
