I/O Hikvision PTZ problem

[bickford 0]

Hello everyone i recently bought a HIKVISION DS-2DE5220IW , on the datasheet nothing

is explained about I/O input output , anything know how to use them please ? For example i would like to trigger PTZ preset with motion

detection or with Input

 

Thanks very much

[Securame 0]

Besides the datasheet, you've got a 109 page manual to read.

 

http://www.hikvision.com/en/Products_accessries_497_i5946.html

[bickford 0]

Thanks for this reply...

 

have you read it ?

 

for me its done and nothing about I/O ...

 

BICKFORD

[ak357 0]

Thanks for this reply...

 

have you read it ?

 

for me its done and nothing about I/O ...

 

BICKFORD

Read again

page 67-68

[bickford 0]

I have read this but nothing is explained about electrical contacts of the camera.

 

I would like to go to a ptz preset when a switch is closed (door bell for example).

 

when i close input 1 (normally open), the input 1 is triggered it is ok ; but when I release the contact the camera returns to its initial position and the action does not end.

 

I would like the ptz preset stay for 30 seconds after input 1 is triggered.

[Securame 0]

Then make a patrol.

[bickford 0]

Then make a patrol.

 

Same things patrol with 1 position and 2 position, when I release the contact the camera returns to its initial position

[Securame 0]

Try this; on that PTZ you have two alarm inputs, and one alarm output.

 

Make the alarm input 1 trigger the alarm output 1, with a delay of 30 seconds on alarm output 1. And then connect (wire) the alarm output 1 to the alarm input 2, and make alarm input 2 trigger your desired preset/patrol.

[mr tahir 0]

hi i need to live view of cctv but hik online is shutt down for 2 months if any person know other software then tell me i also use the client ivms4500 in mobile and p2p cloud but i can't see live view wehn i entere the device information in p2p the option is apeared that the device is used othe user can any person tell me how to delete other user and from where?

[alanduy1 0]

its user end preset sttings for each camera. Do u even have a keyboard for controlling the PTZ camera. if not, u better get one

[bickford 0]

Try this; on that PTZ you have two alarm inputs, and one alarm output.

 

Make the alarm input 1 trigger the alarm output 1, with a delay of 30 seconds on alarm output 1. And then connect (wire) the alarm output 1 to the alarm input 2, and make alarm input 2 trigger your desired preset/patrol.

 

I will try this

 

Thanks very much !

 

BICK