towersites 0 Posted January 18, 2018 I still have a few NET300R's and NET300T's running on a network. They continue to work OK but I have a few additional units in storage at the shop that I cannot reconfigure. For example I can access a NET300R with a laptop running Windows 7 through an ethernet cable, I can see the General Setup page no problem, but if I click on any of the subpages such as Network Setup or Video Decoder Settings, it brings up a page that is mostly blank, the area where I used to see configuration and other data is just blank. I used to be able to access these with an older laptop running XP. Has anyone seen this particular issue? I can send a screen shot if someone wants to see what I'm seeing. Terry Share this post Link to post Share on other sites
jazzar 0 Posted February 28, 2018 This can be a number of things primarily the security levels of windows 7. In past i have had to set up active x to run as unsecured ie minimum restrictions to get the active x components to load Also set ip address in as a trusted site. Possibly use f12 on internet explorer and set to run im emulation mode of ie8 etc And even set the ip address as a trusted site under java controls . Windows 7 is most likely causing the issue. Try googling each of the above. Share this post Link to post Share on other sites
