Can't access Hikvision NVR after resolution change

[katmandude 0]

Hi all, got myself into a pickle here. I changed Hikvision NVR resolution to max 4K and also changed output fro VGA to HDMI...system rebooted.

Upon startup there is no HDMI output received by monitor (black screen) and the VGA output does show camera feed like before. However I cannot change anything back as the mouse doesn't show the cursor on the screen anymore. It is lit up red so I know it is connected and did try another mouse to verify. I tried to change resolution back through laptop Hikvision CMS Client software but that function isn't there. 

Since I am still getting VGA signal but no system control with mouse now, I am thinking the monitor can't handle the higher resolution setting and locked up in VGA? And now I simply need to spend a small fortune on a 4K monitor?

Is there a way to hard reset this NVR without the use of a video screen and mouse or am I screwed? 

[tomcctv 190]

Hi. You have two options . Either plug your unit into a friends 4K TV 

or use your PC to go into configuration of your NVR 

you will need to be on same network as your NVR 

 

you also need this software

 

https://www.hikvision.com/en/Support/Downloads/Tools

 

[katmandude 0]

Thanks, I was able to use PC. I found the configuration section where I was able to undo what was done.

System rebooted, back to normal....

Oh, dunno what that software link is you have there, it comes up as a non-existent URL...404 page not found

...peace

[tomcctv 190]

Hi was a link to the hikvision SADP tool

[REZG 0]

Please  help me i have the same yuor self when  i chang the display resolution in my dvr hik VISION  and now the moniter shows no signal.

 

Can you help me about how use our PC direct without ip or net to go into configuration of our NVR .