PROBLEM WITH DVR FLOUREON

[kostikas 0]

i have made the installation

i have put the cameras

i have connected to the internet

i have installed the app in my android and it is connected

but no picture in the monitor or in my app

i ntested the voltage that goes too cameras its ok

any help????

[tomcctv 190]

Hi when you say no picture on monitor does that also mean no gui .... is it just full blank ? 

Is your monitor comparable with recorder output ... is it hdmi or vga output 

how did you setup app if unit has blank screen ..... has it ever shown cameras

what type of system do you have analog or ip

[kostikas 0]

i have analog system

monitor vga xconnection

i see the menus ok

i see also in app

but its black picture in camera and in app

blank

i checked the voltage from pak to cameras its 12v.i dont know what is wrong..its impossible 4 cameras to me off.maybe the circuit inside .the plaket of the dvd

[tomcctv 190]

How many cameras on your power supply and what size is it

also did you buy as a kit or camera recorder or separate 

 

also so have you installed a hard drive

[kostikas 0]

i have 4 cameras

i bought from gearbest the set 

https://www.gearbest.com/surveillance-camera-system/pp_1253461.html

first i thought i put the bnc that was for camera to the dvr but this was all right

the hard dsik is ok

now i think maybe was wrong to put the bnc to the back of the dvr while this was powered on

i dont know what to do really

[tomcctv 190]

Hi. Your link does not work .

what size is your power supply and how long are your cables .

some of the floureon systems come with two power adapters but look the same 

1 is 4amp and the other is only 2amp ........ Have you got them mixed up 

2amp is for recorder and the 4 amp is to power cameras 

[kostikas 0]

i dont have them near me

they look the same

but i changed them for sure 

i put the one to dvr and the other to cameras and viseversa

the cables are 18 metres long

it was all in the kit 

 

https://www.gearbest.com/surveillance-camera-system/pp_1253461.html

[tomcctv 190]

One more test ....... Remove the pigtail power lead and just plug one camera direct into camera ..... If that does not work then you have a faulty unit 

 

if your seeing the menus on your screen but not cameras then it's not out of range

[kostikas 0]

what do you mean.remove all cameras from the back?and leave only one bnc from one camera?but i must give voltage to this camera from one of the 4 jacks that are available in the power supply of the cameras.right?

 

[tomcctv 190]

Hi. Only have 1 camera connected to dvr and only plug the power supply into that camera without the cat tail