DNS failed in the dvr

[alarme4u 0]

Hi.

I have a problem regarding internet conection. In picture attached Primary DNS and Secondary DNS are 0.0.....

It should be same as Gateaway the Primary DNS and Secondary DNS should be 8.8.8.8.

I tried to change them but it doesn't keep the changes i make.

I tried to give an update but still not solved my problem.

I tried to write again the Eeprom chip and still not solved.

I think is a hardware problem because after it starts the dvr gives a long beep and another new one doesn't stats with a long beep.

The dvr is bought from China.Brand is H.view and model is AVR-AE204.

[larry 2]

DHCP is enabled (i don't know whether this generic nvr is receiving or setting these values) so what is setting these network values? Is it setup correctly?

[alarme4u 0]

Factory settings are this from picture below.

The dvr worked perfect for about 2 months and after stoped working on the internet.

[alarme4u 0]

Check message i recive.

[tomcctv 190]

Hi. Switch to DHCP enable .... Log out then back into network settings and see if setup it's self 

primary dns is 8.8.8.8

sec bans .    Is 8.8.4.4

you have the Xmeye unit . Did you use the QR setup the first time you used it

[alarme4u 0]

I tried to change DNS in Dhcp enabled mode but didn't worked. I will try again using the numbers you gave me. 

I don't think i used QR setup first time i instaled it.

[tomcctv 190]

11 minutes ago, alarme4u said:

I tried to change DNS in Dhcp enabled mode but didn't worked. I will try again using the numbers you gave me. 

I don't think i used QR setup first time i instaled it.

What router are you using ? If your not using QR you will need to port forward your unit

[alarme4u 0]

I tried using what You advised me.

Problem not solved

[tomcctv 190]

What is the IP address of your router