able1 0 Posted December 29, 2020 I have a customer with a FLIR DNR208P1 NVR and I have a few questions. Wondering if anyone here is knowable enough to answer the following. First, I have set the recorder for video motion. But when I playback video and I turn off the full time record and only have Motion Checked it appears nothing is shown. This is even when their is actual motion detected by a red icon in the lower left of the screen and all cameras are programmed to record during motion. Then again any chance anyone knows of a Tech Support phone number for the FLIR NVR products. OR Is this product line non-existent and I am beating a dead horse?? Thanks in advance for any assist. Les Share this post Link to post Share on other sites
tomcctv 190 Posted December 29, 2020 Hi les Red indicates alarm ...... yellow is motion..... green is always record flir never made a domestic nvr it was made under licence by dahua when Flir owned lorex lorex is now owned by dahua so lorex is your support help or look for dahua manual that’s 5 years old Share this post Link to post Share on other sites
able1 0 Posted December 29, 2020 Thanks Tom for narrowing down the focus. Going to chase down Lorex. BTW during playback when I un-check the green the bar goes blank. Which seems to me that no recording during motion?? Thanks for the quick reply!! Les Share this post Link to post Share on other sites
able1 0 Posted December 30, 2020 Hi Tom, I am not sure but I may have my answer. I located the install manual. I noticed the selection spot on the screen is either a White Square or a Black Square. Clicking on change the color. What is a bit confusing is which color is the active selection?? I was thinking when I was there today that I should use White. However, I am starting to think that I was wrong and it should be Black. Can you direct me towards the correct Color?? Not that I read the "entire" install manual but it does not show up that I can see. Thanks for the assist, Les Share this post Link to post Share on other sites
able1 0 Posted January 3, 2021 Well it seems that know one knows the answer to the question. Is it either Black or White?? After much time playing around and by the rules of Deductive Reasoning I have determined the answer. It would have been much easier had there been a Check Mark in the square. ✅ Happy New Year ALL!!! Les Share this post Link to post Share on other sites
Bash101 0 Posted February 17, 2021 It may not be the case here, but on some systems I’ve seen, where I’ve replaced a camera on NVR with motion recording. The motion recording setting on the camera webpage setup has had to be enabled as well as the NVR setting before it will record on motion Share this post Link to post Share on other sites
