Royal T 0 Posted December 30, 2021 Hi I am about to purchase a cam system for my hm and shop the distance between the two is 200ft my concern is stray voltage induced it my cabling from other sources I am not sure which cable to use Rg6 would be preferred due to size and being more flexible and the fact there is already 1 1/2 pcv conduit in ground, In the back shop I have a milling machine with a 3 phase converter in the front I have a 1750hp Eddy current chassis dyno my question is how far away from these devices does the cable have to be ? [of course at night they are not in service and during the day only part time ] and how far away from 110v romax wire i have read not to make runs parallels to high current My conduit is installed with a run in the hm right next to each other for 3 ft my equipment is about 15 feet from any camera or cable run i plan but i must pass over 110v wiring how far away from the 110v do i need to be ? I need to run for 8 cameras into the shop and around the building should I use shielded wires wireless is out of the question any thoughts would help . thanks Royal T Share this post Link to post Share on other sites
tomcctv 190 Posted December 30, 2021 Hi I would go cat5 much easier to work with and gives you more options do both locations have the same power feed 1 Share this post Link to post Share on other sites
