blowrabbit 0 Posted October 1, 2006 has anyone had any success actuating changes in camera or recording settings thru wavereader [remotely]? I do it thru the menu but the changes dont really happen? Share this post Link to post Share on other sites
rory 0 Posted October 1, 2006 Yeah man .. plenty of times .. are you having issues doing it? Download from DVR, make changes, Upload back to DVR ... Depending on Bandwidth/DVR Model you may have to disconnect to see the changes. Rory Share this post Link to post Share on other sites
blowrabbit 0 Posted October 1, 2006 i think i just figured it out that you can not do any changes during recording mode. that is with time lapse recording. and yea your right upload your current settings first then change them. Share this post Link to post Share on other sites
rory 0 Posted October 1, 2006 Shouldnt be an issue if the DVR is recording, though the DVRs i installed were always set up to motion record .. but im sure they were recording at times when i uploaded the changes. Share this post Link to post Share on other sites
blowrabbit 0 Posted October 3, 2006 i went to the site to check on the condition of the changes and they werent there? I would be curious to pm you the ip address and password to the dvmre ct 160-A to see if you can do anything to see changes in the AGC ? Pm me if you have the time if not, dont pm me. Again thanks you are the master. "when you can grasp the peble ... grasshopper" Share this post Link to post Share on other sites
