aardwolf 0 Posted August 11, 2007 Hey, I'm trying to get this PTZ camera on this 16ch 120/fps card. The camera runs in PELCO-D. I set the configuration in the set up with Pelco-D and and enabled the PTZ functions. However, I am using a RS485-RS232 which goes into the motherboard PORT A. So on diginet I set it to com port 1.Does the PTZ A+ and B- PTZ wire go directly to the board. In the diginet manual it say I need Rx RECEIVER(HRE-301 or HRE 302). Do these wires go onto the pins on the board??? Share this post Link to post Share on other sites
