AV760 disable beep alarm

[maocopy 0]

Hi,

I am not able to configure AV760 using recording on motion detection and without any beep.

 

The problem is that the DVR is on the same room and I don't wanna noise.

 

is it possible?

 

what about firmware upgrade, some errors need to be fixed?

[scorpion 0]

Press menu

select ADVANCE

select ALERT

go about 4 lines down select MOTION

PUSH ENTER

This should change it to NO

 

Now you will not hear any beeps when your "cameras" detect motion.

 

Press menu to go back out of the "pages".

 

Let me know how it worked.

[scorpion 0]

Press MENU

select RECORD

select OVERWRITE This should say yes. When the hard drive is full it will loop back and record over the oldest video footage going in to a "loop".

 

press MENU to get out of this page

 

select ADVANCE

select DETECTION Move the cursor to the second column marked DET, make sure it says ON for all of the cameras that you have hooked up.

 

Now move the cursor to the third column marked AREA. On cam one press enter. If the page is pink then this is not seeing "motion", if it is clear than it is looking for motion to trigger recording.

 

Here is the hard part to describe. Find where the cursor is blinking (probably around the center of the screen somewhere) using the left arrow move it to the far left of your screen, using the up arrow go all the way to the top of the screen. Press enter (this marks a starting point), move the cursor down to the bottom of the screen, (do not touch any buttons except arrow/directional buttons), when you get to the bottom of the screen use the right arrow, and move the cursor to the right.

 

Here is what you should be seeing. When you pressed enter at the top of the screen the square went from pink to clear, as you pressed the arrow down the whole column became clear. As you used the right arrow the screen slowly became clear as you worked your way to the right.

 

When you get to the right side of the screen you can move your hand in front of a camera and you will see all of the squares "activating" as it follows your movements. Press ENTER to stop the selection process. You are now good to go for motion detection.

 

Press MENU to back out of camera one area, and press the down arrow to get to camera two area. Press ENTER, and repeat steps for each camera.

 

Here is a trick. If you have some outdoor cameras, and you have some bushes, trees, ect, then you can set up motion masking. Now the bushes, and trees will not trigger your cameras.

 

Move the cursor to where you want to start a motion area. Start at the top of this area, press enter, go down as many squares as you need then work your way to the left or right to make a "motion" box. Press enter to stop the selection process. You can now freely move the cursor. Go to your next area that you want motion detection, and make your box, rectangle, or just go wild to get all of the nooks, and cranny around moving objects.

 

Press menu to get out of AREA, press menu to get out of Detection.

 

Go to RECORD

go to manual record

press enter. It should say YES

Press menu to get out of the menu pages.

 

THIS IS NOT THE COMPLETE INSTRUCTIONS FOR SETTING UP THE DVR!

 

For others who are reading this post.......

 

This is where most people have problems setting up the DVR. You still need to set the date time group, record quality, ect, ect.

 

If anyone else needs help start a new thread, and I will be more than glad to help.

 

If you have lost your manual that is not a problem. I charge $500.00 for a new copy!!!!! LOL! I was joking!

[maocopy 0]

 

Let me know how it worked.

 

 

yes it works perfectly

 

thanks everybody

 

great product the av760