rdawg 0 Posted November 3, 2007 Guys, i have a sensormatic speedome 2000 ptz camera. When i power it up it goes throught its rotation but then i cannot get it to TILT everything else works except the tilt. Does anyone know anything about these or what the problem is. Share this post Link to post Share on other sites
scorpion 0 Posted November 3, 2007 Too many variables! What is your level of expertise on these products? I assume you know how to put in an address for the camera? I assume you have the + wire, and the - wire hooked up correctly? I have assumed that you have reversed the wires as a troubleshooting procedure? Is this the same camera that you were having problems with before? http://www.cctvforum.com/post-67929.html Is there anything in this topic that can help? http://www.cctvforum.com/viewtopic.php?t=1110 Share this post Link to post Share on other sites
rdawg 0 Posted November 3, 2007 I have everything set correctly. I have another camera that i hooked up the same way and everything works fine on it. "this " camera will power up, go through its rotations(iris,zoom pan, tiltwork during rotations) then when i try to controlit nothing happens. all wiring looks ok Share this post Link to post Share on other sites
scorpion 0 Posted November 3, 2007 What are you using to control it? ADTT16e? Share this post Link to post Share on other sites
scorpion 0 Posted November 3, 2007 (edited) What about setting it to an address, then let it go through it's start up procedure, and then changing the address again, and let it go through the start up procedure again. I was wondering if this would force it to re-evaluate the system? For others reading this post: http://www.integraltech.com/FileDownloads/901c55_Integral_PTZ_RS-422_Field.pdf http://www.tycovideo.com/products/speeddome_housing_ultra_indoor.aspx Edited November 3, 2007 by Guest Share this post Link to post Share on other sites
rdawg 0 Posted November 3, 2007 I have camera set to #1 and after it goes thru its rotation i plug the controller in (already set to #1 and still notyhing Share this post Link to post Share on other sites
scorpion 0 Posted November 3, 2007 was it set to an address originally, and then you changed it to #1?? Share this post Link to post Share on other sites
UMDRanger 0 Posted November 4, 2007 Does it tilt during it's bootup rotations? If not, check the tilt motor. If so, I'm outta guesses. Share this post Link to post Share on other sites
sam10693 0 Posted December 10, 2007 Hi personally it sounds like the tilt moter is buggered sorry but hope this helps Share this post Link to post Share on other sites
