noreason 0 Posted December 6, 2007 I recently came across a bosch autodome camera that I'm having a hard time finding information on. The camera itself when i pull the cover off shows LTC 0828/20ND G3 Envirodome but when the camera boots up it says Philips G3A Autodome with the date of 2002. What I'm trying to figure out is how to control this camera. What protocol does it use? Can I connect it via rs232? I'd like to add it to my geovision setup but I cant seem to figure out how to control it. Any help on this dome would be appreciated. Share this post Link to post Share on other sites
RickA 0 Posted December 6, 2007 Here is a link to the manual http://www.boschsecurity.us/pdf/EN/Adome_II_43816.pdf Hope this helps. Share this post Link to post Share on other sites
noreason 0 Posted December 6, 2007 The manual says rs-232, rs-485 and pelco protocol if the firmware is high enough but the problem is I don't even know the firmware version. If i just use pin 2 and 3 on a standard com port is that sufficient for a rs-232 cable or am i missing something? Thanks again Share this post Link to post Share on other sites
