Jump to content
VScope

problems with install speco dome camera

Recommended Posts

installing speco IR vandal dome. disconected video from test monitor. reconected video to run. lost picture at the head. changed connects still no

picture to monitor, have power to camera. using RU59 cable about 150 to homerun. When i connect back to test montior i have video. Any ideas were i went wrong would be helpful ! thank you

 

vscope

Share this post


Link to post
Share on other sites

Check BNC connections at camera and at DVR, use test monitor to see if video is present at DVR end. May need to reboot DVR to re establish connection.

Share this post


Link to post
Share on other sites

A trick I use to test RG-59 is place a resistor accross the shield and center pin on one connector, and meter it at the other end. You should get the proper resistance (makes double checking those twist-on BNCs a breeze).

 

Likely a bad install on the BNC, or the cable is damaged somewhere along the 150' run.

 

Also - Try what Rick suggested.

Share this post


Link to post
Share on other sites

Thank you RickA and UMDRanger very much will try tomorrow. hoping it is

not the cable ! i have it piped. i will let you know the turn out.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×