radman 0 Posted January 16, 2008 I am trying to work out the wiring on a H6ZBME-5P Cosmicar/Pentax lens they are as follows:- 2 White---- 2 and 5 loosely shown linked like this [ 5 Blue ---- + 12v Near 4 Green ---- 4 and 6 loosely shown linked like this [ 6 Red ---- + 12v Tele 7 Orange ---- Pot Supply 8 Grey---- Pot Return 3 Sky Blue ----Wiper Focus 1 Pink ---- Wiper Zoom So I am assuming 2,5,4,6 and 7 are all 12v +ve and 8 is -ve Pins 3 and 1 go to the respective outputs from the control board It's a bit confusing if the above is correct why did they not connect 2,5,4,6 and 7 internally! or am I reading it incorrectly? Thanks, John. Share this post Link to post Share on other sites
radman 0 Posted January 17, 2008 I am trying to work out the wiring on a H6ZBME-5P Cosmicar/Pentax lens they are as follows:- 2 White---- 2 and 5 loosely shown linked like this [ 5 Blue ---- + 12v Near 4 Green ---- 4 and 6 loosely shown linked like this [ 6 Red ---- + 12v Tele 7 Orange ---- Pot Supply 8 Grey---- Pot Return 3 Sky Blue ----Wiper Focus 1 Pink ---- Wiper Zoom So I am assuming 2,5,4,6 and 7 are all 12v +ve and 8 is -ve Pins 3 and 1 go to the respective outputs from the control board It's a bit confusing if the above is correct why did they not connect 2,5,4,6 and 7 internally! or am I reading it incorrectly? Thanks, John. The answer is using the common connection on the control board join 5 and 4 together use 2 to the focus connection and 5 to the zoom the rest are not used unless you are using feedback to a telemetry monitoring system Share this post Link to post Share on other sites
