"No Privilege" Error Message

[andy_geovision 0]

There are a couple reasons for you have " No privilege " on the webcam.

 

1. Check your account status.

In the GeoVision System, go to Configure icon >> Password Setup >> Local Account Edit.

Please create a new UserID as supervisor and try it.

 

2. Recording by schedule.

If you have setup a schedule for recording, check the following. Otherwise, skip this step.

In the GeoVision System, go to Schedule icon >>Schedule Edit.

Did you put a check mark right next to " view ".

 

 

3. Remote Authentication.

Did you accidentally setup an remote authentication server?

In the GeoVision System, go to Configure icon >> Password Setup >> Remote Authentication Setup.

Did you see the following window? If you did, please let me know...

 

4. Reset passwords.

In the GeoVision System, go to Configure icon >> Password Setup >> Local Account Edit.

Check a box called " allow removing password system.

 

Close the GV system.

Go to C:\GV folder\ PassUnInstall.exe.

Double click that and reset the password.

 

Now enable the webcam server and try it.

 

Any questions, let me know.....

 

Sincerely,

 

Andy Chen

 

Technical Support

GeoVision. Inc.

+886-2-8797-8335 ext 287

[shanekennedy 0]

i'm getting the "no privlege error" using remote-view & webcam view

 

doesn't appear to be a acct/password issue. when i turn off scheduled recording, it works

 

i have 2 schedules, & both have the "view" box checked

 

schedule 1 is for camera 1 & 2. they both work w/ remote view. it's on motion-detect all day from 00:00 to 00:00

 

schedule 2 is for camera 3. it doesn't work w/ remote view. it's on motion-detect from 21:00PM until 08:00AM

 

the time & camera #'s are the only difference in the 2 schedules

 

any suggestions?

[shanekennedy 0]

think i found my problem

 

it appears you can only view a scheduled camera during it's schedule

 

so i can only view my cam3 between 21:00 & 08:00

 

if i try to view @ 20:00, i get the "no privlege" error

 

is this a bug or a feature ?

 

is there some way to remotely view the camera 24 hrs a day, but only record between 2100 & 800 ?

[ezCCTV 0]

Set up a schedule for the time in between recording, untick Record, and tick Remote

[alexc 0]

Andy,

In #3 you mention accidentally creating an authentication server. What window should I be looking for to check? I did not see, in your post, the window to look for.

[DIOPSU 0]

I have the same problem in

 

 

3. Remote Authentication.

Did you accidentally setup an remote authentication server?

In the GeoVision System, go to Configure icon >> Password Setup >> Remote Authentication Setup.

Did you see the following window? If you did, please let me know...