petelang 0 Posted February 17, 2008 I just picked up a CPD501 4 channel DVR with Nuvico CB-SD3895-L cameras. When I plug in the DVR it makes a Beep noise and I don't get any video out of any port. I've tried using a VGA cable to my HDTV and a BNC to 75ohm converter to the same TV. Is there something I'm doing wrong. Share this post Link to post Share on other sites
scorpion 0 Posted February 17, 2008 I am not quite sure what problem you may be having. I assume you have four cameras hooked up to the DVR. I assume you have a bnc to rca adapter connected to the MONITOR. With an RCA cable connect this to a yellow connector on your tv set. Do not use the threaded connector on the back called the F connector. This is for an antenna, or for cable service. If you do not know how to activate the yellow connector then try this article http://www.cctvforum.com/cms_view_article.php?aid=41 Scroll down to "On some TVs to activate the composite signal it is a simple as "..... Are you using NTSC, or PAL? 5.3 SWITCH N/P SYSTEM (ntsc/pal) 1) Press “Power†Share this post Link to post Share on other sites
petelang 0 Posted February 19, 2008 I am not quite sure what problem you may be having. I assume you have four cameras hooked up to the DVR. I assume you have a bnc to rca adapter connected to the MONITOR. With an RCA cable connect this to a yellow connector on your tv set. I was using a BNC to Coax adapter. I'll go to Rat Shack and pick up a BNC to RCA Video adapter. Thanks for the tip. Pete Share this post Link to post Share on other sites
scorpion 0 Posted February 19, 2008 Keep me posted! Thanks! Share this post Link to post Share on other sites
petelang 0 Posted August 20, 2008 Keep me posted! Thanks! That worked sorry for the long delay in getting back to you. I'm researching another issue and came back to this post. Pete Share this post Link to post Share on other sites
