hyouhaku 0 Posted May 21, 2013 Hi all, I just bought the lorex lnr280 with 4x 1080p cameras and figured out that I cannot just plug the cameras into my switch(with poe) for some strange reason. So my question is: is there any custom firmware available out there that allows me to change network configuration of the nvr? Share this post Link to post Share on other sites
zikronix 0 Posted May 21, 2013 switch needs to be a poe switch default ip of cameras are 192.0.0.64 username admin pass 000000 put your computer on the same subnet and then you can access the cameras via the web Share this post Link to post Share on other sites
seawiiz 0 Posted May 27, 2013 I got the same system. Set it up as instructed and can access intranet ok. Internet unsuccessful. Have to wait for holiday to call Lorex for technical assistance. I think the ddns account they setup is not correct. The instruction is confusing and is not complete. Share this post Link to post Share on other sites
JoeyJoey 0 Posted May 27, 2013 Hi all, I just bought the lorex lnr280 with 4x 1080p cameras and figured out that I cannot just plug the cameras into my switch(with poe) for some strange reason. So my question is: is there any custom firmware available out there that allows me to change network configuration of the nvr? You can do as you did, but you have to manually add the network cameras. No custom firmware is need to access the nvr on the network. Share this post Link to post Share on other sites
