ptzguy 0 Posted September 5, 2010 Hi guys/gals, I reinstated a setup yesterday for a guy that had had his DVR unplugged for several months. He also asked if i could configure his DVR for remote viewing, I have asked him to get a static ip address whilst i do my home work. There's no manual with the DVR and it's the 1st Eneo i have worked with. The DVR itself I'd say is an earlier model as i'm getting no luck with Eneos website/downloads. It's a 4ch cream box very very similar to the DLR series but no DVD/CD drive, in the network menu you have only options to change the IP address and subnet mask, or change users password... no mention of ports etc.... The newer Eneo models have 3 or 4 ports to be mapped/opened through the router(like all the DVR's I've previously worked with)... So... are the ports set to default values Is the RAS software a must, these DVR's cannot be viewed using IExplorer web browser Any help or advice would be much appreciated, and thank you in advance for all replies. Regards, ptzguy Share this post Link to post Share on other sites
